The Ecosmart Eco 36 is a high-efficiency, low-NOx gas water heater that operates on a modulation technology to provide an optimal balance between performance and efficiency. If you're looking to install this eco-friendly unit in your home or business, you're in the right place. Here's a comprehensive, step-by-step guide to walk you through the Eco 36 installation process.
Before you begin, ensure you have the following components and tools ready: your Ecossmart Eco 36 water heater, a licensed plumber or gas fitter, tee fittings, union connections, stainless steel vent, saddle valve,VCV (Vent Control Valve), gas pipe, and the necessary wrenches and screwdrivers.
Unpacking and Preparing the Eco 36
The first step in your Eco 36 installation journey is to carefully unbox and inspect your water heater. Ensure all components are present and that the unit itself is undamaged.
Once you've confirmed everything is in order, allow the unit to sit upright in its resting place for about three hours. This helps the oil inside the burner to settle, preventing any potential leaks or malfunctions during installation.
Venting the Eco 36
One of the Eco 36's key features is its ability to be vented through the side or the top. For optimal performance, we recommend side-venting. Carefully cut and install the stainless steel vent according to the unit's specifications, ensuring it's secure and properly connected.
It's crucial to note that the vent must extend at least 12 inches above the roofline or other obstructions. Also, maintain a minimum clearance of 18 inches fromcombustible materials to prevent any fire hazards.
Connecting the Gas Supply
The Eco 36 operates on a flexible 3/4" gas supply line. Begin by installing a tee fitting and saddle valve to the existing gas line. Then, connect the gas line to your Eco 36 unit using a union connection to ensure easy disconnection if needed in the future.
Remember to leave enough pipe length for future service and maintenance. Also, ensure that the gas supply valve is securely tightened, but avoid overtightening to prevent damaging the valve.
Installing the Eco 36 Water Heater
Now that the venting and gas supply are in place, you're ready to install the Eco 36 itself. Position the unit on a stable, level surface and secure it in place using the mounting screws provided.
Next, connect the cold and hot water supply and drain lines. Use new tubing and make sure to secure the connections with appropriate clamps.
Installing the VCV (Vent Control Valve)
To complete your Eco 36 installation, you'll need to install the VCV. This safety device ensures proper venting and prevents carbon monoxide backdrafts. Install the VCV on the main vent stack and connect it to the Eco 36 unit according to the manufacturer's instructions.
The VCV should be installed on a horizontal vent run, and it's important to ensure that no other appliances share the same vent to prevent any cross-contamination or venting issues.
Performing the Final checks and Testing
With the Eco 36 fully installed, it's time to perform final checks and tests before powering up the unit. First, visually inspect all connections to ensure they're secure and without leaks. Then, use a pressure test gauge to check the water pressure at the inlet side of the water heater. The pressure should not exceed 80 psi.
Once you're satisfied with the water pressure, you can proceed to test the gas supply. Turn on the gas supply valve slowly, and listen for any hissing noises that could indicate a gas leak. If all checks out, you're ready to power up your Ecosmart Eco 36 water heater.
Congratulations! You've successfully installed your Ecosmart Eco 36 water heater. As a final note, always make sure to disconnect the power before performing any maintenance or servicing on the unit. Regular maintenance will ensure your Eco 36 continues to operate at peak efficiency and longevity. Enjoy your hot water while keeping your carbon footprint in check.