Ready to upgrade your home's heating efficiency and sustainability? The Ecosmart ECO 11 is a reliable and energy-efficient electric tankless water heater that's easy to install, maintain, and use. Let's guide you through the process of Ecosmart 11 installation, ensuring optimal performance and longevity of your new eco-friendly heating solution.
Before we dive into the installation process, it's crucial to ensure that your home's electrical system and plumbing infrastructure can accommodate the Ecosmart ECO 11. Consult the product's specifications and consult a professional if you're unsure about any aspect of the installation.
Preparation and Planning
Thorough preparation is key to a successful Ecosmart 11 installation. Gather all necessary tools and materials, including a voltage tester, wire stripper, screwdriver, Teflon tape, and pipeibng assemblies.
Carefully review the installation manual and ensure that you understand the wiring diagram and plumbing connections. Measure and double-check all components to avoid any installation mishaps.
Shutting Down Utilities
Safety first! Begin by turning off the power to your water heater at the main electrical panel. Then, close the cold and hot water valves and drain the tank to avoid any water damage during the installation process.
Drain the tank by connecting a garden hose to the drain valve and running it to a suitable drain location. Open both hot and cold water valves at the top of the tank to release any remaining pressure and water.
Mounting the Ecosmart ECO 11
Choose a location for the Ecosmart ECO 11 that is close to both your water supply and electrical power source. The optimal height for installation is between 36" and 72" from the floor. Mount the heater using the included brackets and screws, ensuring it's level and secure.
Run a pipe through the wall or floor, depending on your chosen installation location. Make sure that the pipes and heater are sloped correctly to enable proper drainage of any condensate that may form within the heater.
Plumbing the Ecosmart ECO 11
Connect the cold water supply line to the Ecosmart ECO 11, using a dielectric union to connect the copper supply pipe to the brass fitting. Ensure that the union is properly tightened and uses Teflon tape to create a watertight seal.
Connect the hot water outlet pipe from the heater to the hot water supply line. Again, use Teflon tape and a dielectric union to ensure a proper connection.
Wiring the Ecosmart ECO 11
Before connecting any wires, double-check that the power is still OFF at the electrical panel. Connect the green (ground) wire from your electrical supply to the green screw on the heater. Next, connect the black (hot) wire to the black terminal, ensuring that the connection is tight and secure.
Connect the white (neutral) wire to the white terminal on the heater. If your electrical supply has a ground wire, connect it to the ground terminal on the heater. Finally, use electrical tape to secure all wire connections.
Testing the Ecosmart ECO 11
Carefully restore power to the electrical panel and monitor the Ecosmart ECO 11 for any signs of leakage or malfunction. Once you're satisfied that the heater is functioning correctly, slowly open the hot water valve to allow water to enter the unit.
Listen for any air escaping through the plumbing system and monitor the hot water faucets for signs of proper operation. If everything is functioning as expected, you've successfully installed your Ecosmart ECO 11!
Enjoy the comfort and efficiency of your new electric tankless water heater. Regular maintenance inspections and seasonal checks will ensure optimal performance and longevity for your Ecosmart ECO 11. Don't forget to register your product with Ecosmart to take advantage of their limited warranty. Happy heating!